The cable diameter can be adjusted according to the two knobs on the "shifting actual operation board". It can detect the specific value of the cable diameter on the "cable diameter meter". When the cable diameter reaches the specified value, set the vernier caliper into the fully automatic state, and set the "diameter input" switch on the control panel of the main control chip into the "on" position. At this time, the knob can be manipulated to carry out adjustments according to the rotation speed ratio of the rotating server.
Observe the tightening situation. If the unwinding supporting force is too large or too small, the edge can be adjusted according to the supporting force sensor of the unwinding control cabinet. If the ranking rate is too fast or too slow, the number of sensors can be adjusted. If the total width of the inside and outside of the row is wrong, the distance between the limit switches can be adjusted.
After plugging in and everything is normal, you can choose fire and non-standby. This actual operation can be selected according to the "skin selection" power switch on the unwinding control cabinet.
According to the meter on the unwinding control cabinet, the number of meters for "metering prediction analysis" or "metering termination" can be set for each axis. You can choose "Offline Standby" or "Offline Not Standby" on the main control chip box.
In the actual operation of temperature control, the temperature control switch can be turned to the heating part in the main control chip box, so that the temperature control instrument can be plugged in. After the temperature control instrument is powered on, press the "set" key, and the set value of the temperature control instrument will be highlighted. Adjust the set temperature to the specific required value according to the up and down keys. Press the "set" key again, the preset value of the temperature control instrument will no longer flash. When the temperature control instrument heats up, the "out" emerald green indicator light on the temperature control instrument lights up. When the temperature is too high, the "alarm" bright red display light is on, and the extruder screw refrigeration centrifugal fan can be selected according to the switch on the main control chip box. If it is working, the emerald green indicator light on the main control chip box is on, indicating the fan.
