1. Preparation before starting
1 According to the production tasks, check whether the semi-finished products, process documents, tooling, and equipment are complete and easy to use.
2 Check the shift record, whether there is any equipment accident record. Check the rotating parts of the machine. Whether the fasteners are loose or fall off. Add oil to the lubricated parts. The water in the oil-water separator is drained clean, and the oil level in the oil cup must not be lower than 1/3.
When installing the 3 wire reel, the top should be tightened, the cap should be tightened, and the bumper should be pulled down.
4 Adjust the pressure of each valve, brake tension, take-up brake, take-up tension to reach the appropriate pressure.
5 Check whether the mopping floor is reset and whether the protective door is closed.
2. Start-up production
1 Turn on the power of the main unit, set the main unit, the direction of the package, and the set length.
2 Disconnect linkage and switch on single action. Adjust the speed of the host and Baotou to the minimum. Turn on the host first, then the strapping machine, adjust the speed and tension of the strapping, so that the strapping pitch and appearance meet the requirements.
3 Disconnect the single action, connect the linkage, the host speeds up and enters normal production.
4 During the production process, operators must stick to their posts, must not leave their posts, and must not allow non-operators to operate the equipment.
5 During the production process, the operator should keep abreast of the temperature, noise, vibration, etc. of the machine. If there is any abnormality, stop and check in time to remove the fault. If the operator cannot solve it, please ask a professional maintenance worker to solve it.
3. Parking cleaning
1. First carefully adjust the speed control button to the minimum, press the stop button, and turn off the power.
2. Fill in the shift record carefully.
3. Wipe the equipment to keep the inside and outside of the machine clean, clean and free of debris.
4. Tooling measuring tools and semi-finished products are placed neatly.
5. Clean up within 3 m of the equipment.
4. Safety operating procedures
1 After the power is turned on, the indicators can be operated only after the indicators show normal.
2 Prevent crushing and crushing when loading and unloading.
3 The equipment is not allowed to press an emergency stop when it is rotating, (except in emergency situations)
4 The protective photo of the equipment must be closed before the equipment can be operated.
5Before starting the machine, the alarm bell must be pressed to inform the crew to prepare for driving
6 When the operator leaves the equipment, he must stop the machine before leaving.
