At present, small extruders are widely used in China. So what if the small extruder is overloaded?
The mud is too dry. At this time, the dry mud should be taken out first. It is best to remove the machine mouth and the machine head, start the dry material in the machine draining mud tank, then install and operate, and appropriately increase the molding water within the specified range.
After a long period of downtime, the remaining material in the mud tank becomes dry and hard, which will not only be seriously overloaded, but sometimes it will not start. In order to prevent this from happening, when the machine is shut down for more than 8 hours, do not shut off the water in the machine. For the two-stage vacuum extruder, the mud in the mud tank should be properly supplied to keep it moist. Above the day, you should try to open the mud and then stop.
Note: When overloading, the load of the motor is high and the clutch is slippery. At this time, it is forbidden to start it to avoid damage to the related parts, or even cause serious accidents such as crushing the mud tank and the machine head.
